QL-580N
Întrebări frecvente şi depanare |
QL-580N
Dată: 01/05/2020 ID: faqp00001066_003
The print is horizontally compressed and not shaped correctly.
The dirt on the tape feed roller may cause slipping of the paper.
Clean the roller with a cleaning sheet following the steps below:
- Turn off the printer.
-
Hold the DK Roll compartment cover at the front of the printer and firmly lift it up.
-
Remove the DK Roll.
-
Remove the backing paper (2) and insert the edge (1) of the cleaning sheet into the printing unit until the area pointed with the arrow in the diagram below.
- Insert the sheet without removing the part (1).
- Check that the printing surface of the cleaning sheet is upward.
-
Close the DK Roll compartment cover and press the ON/OFF button to turn the printer on.
-
Press the Feed button for more than one second. The roller spins by 4" (10 cm). The adhesive face of cleaning sheet removes the stain or dust on the roller.
- If not pressing the Feed button for more than one second, the roller spins only 1/3" (8 mm).
- Dispose the cleaning sheet after use.
- Open the DK cover.
-
Insert the DK roll.
- Make sure that the spool arms are inserted firmly in the spool guides on the left and right.
- Insert the spool with the DK Roll located on the right side of the printer.
Dacă aveţi nevoie de asistenţă suplimentară, vă rugăm să contactaţi serviciul de asistenţă clienţi Brother:
Spuneţi-vă părerea despre conţinutul furnizat
Pentru a ne ajuta să îmbunătăţim serviciile de asistenţă, vă rugăm să vă spuneţi părerea.
Pasul 1: În ce mod vă ajută informaţiile de pe această pagină?
Pasul 2: Doriţi să adăugaţi comentarii?
Vă rugăm să ţineţi cont de faptul că acest formular este folosit numai pentru feedback.