CM300
![]() |
Întrebări frecvente şi depanare |
Dată: 16/01/2017 ID: faqh00100596_000
What should I do if part of the material is not cut?
If part of the material is not cut, the cutting pressure may not be set appropriately for the material.
Increase the cutting pressure by 1, and then perform trial cutting.
When the blade is strongly pressed against the material, the material may lift off the mat. If you adjust the cutting pressure, increase by 1.
Dacă aveţi nevoie de asistenţă suplimentară, vă rugăm să contactaţi serviciul de asistenţă clienţi Brother:
Spuneţi-vă părerea despre conţinutul furnizat
Pentru a ne ajuta să îmbunătăţim serviciile de asistenţă, vă rugăm să vă spuneţi părerea.
Pasul 1: În ce mod vă ajută informaţiile de pe această pagină?
Pasul 2: Doriţi să adăugaţi comentarii?
Vă rugăm să ţineţi cont de faptul că acest formular este folosit numai pentru feedback.