PE-DESIGN Ver.6
![]() |
Odpowiedzi na często zadawane pytania i rozwiązywanie problemów |
![](/g/b/img/product/hf_design6euk.jpg)
PE-DESIGN Ver.6
Data: 25/02/2009 Identyfikator: faqh00000030_000
When I embroider a pattern with an outline and an inside region, there is a gap (where nothing is sewn) between the outline and the inside region. When the pattern is checked in the "Preview" screen, no gap appears between them. What can I do to finish the embroidery without this gap?
- Make sure the fabric is set tightly into the hoop.
One Point Advice Embroidery
- When embroidering on Stretch or Towel fabrics, try the following:
<In the case of Stretch fabric>
Attach an iron on stabilizer material to the bottom surface of fabric.
Follow the instructions provided with the stabilizer for proper adhesive.
<In the case of Towel fabric>
Place a stabilizer material under the fabric, and hoop the fabric and the stabilizer material together.
Also place a stabilizer material on the top surface of the fabric.
One Point Advice Fabrics and stabilizer material for embroidery
- If the suggestions mentioned above don't improve the embroidery, please try to adjust.
+ "Pull Compensation". Increase the "pull compensation" value if necessary in "Design Center" or "Layout & Editing".
+ Refer to your Instruction Manual for detailed instructions on .
+ Pull Compensation or Applying Sewing Attributes to Lines and Regions.Ver.8 Ver.7 and Ver.6 Ver.5
Powiązane odpowiedzi na często zadawane pytania
Jeśli potrzebujesz dalszej pomocy, skontaktuj się z działem obsługi klienta firmy Brother:
Opinie dotyczące treści
Aby pomóc nam udoskonalać naszą pomoc techniczną, przekaż poniżej swoją opinię.
Krok 1: Na ile informacje na tej stronie były dla Ciebie pomocne?
Krok 2: Czy chcesz dodać własne komentarze?
Prosimy pamiętać, że niniejszy formularz służy wyłącznie do wyrażania opinii.