PE-DESIGN 8
 |
FAQs & Troubleshooting |
PE-DESIGN 8
Date: 25/02/2009 ID: faqh00000030_000
When I embroider a pattern with an outline and an inside region, there is a gap (where nothing is sewn) between the outline and the inside region. When the pattern is checked in the "Preview" screen, no gap appears between them. What can I do to finish the embroidery without this gap?
- Make sure the fabric is set tightly into the hoop.
One Point Advice Embroidery
- When embroidering on Stretch or Towel fabrics, try the following:
<In the case of Stretch fabric>
Attach an iron on stabilizer material to the bottom surface of fabric.
Follow the instructions provided with the stabilizer for proper adhesive.
<In the case of Towel fabric>
Place a stabilizer material under the fabric, and hoop the fabric and the stabilizer material together.
Also place a stabilizer material on the top surface of the fabric.
One Point Advice Fabrics and stabilizer material for embroidery
- If the suggestions mentioned above don't improve the embroidery, please try to adjust.
+ "Pull Compensation". Increase the "pull compensation" value if necessary in "Design Center" or "Layout & Editing".
+ Refer to your Instruction Manual for detailed instructions on .
+ Pull Compensation or Applying Sewing Attributes to Lines and Regions.Ver.8 Ver.7 and Ver.6 
Ver.5
Related FAQs
PE-DESIGN 8, PE-DESIGN Ver.5, PE-DESIGN Ver.6, PE-DESIGN Ver.7
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.