CM600
Vanlige spørsmål og feilsøking |
CM600
Dato: 10.07.2017 ID: faqh00000698_000
The mat is fed in at an angle and is not fed during cutting / drawing.
Possible Causes (or Results)
- The mat’s adhesive strength has decreased, or the material is not secured.
- The material extends from the adhesive area of the mat.
Solutions
-
Press the “Start/Stop” button to stop the operation.
-
Follow the instructions on the screen, and press the “Feed” button to feed out the mat.
If the mat does not feed out, turn off the machine (1), remove the holder (2), and then manually feed out the mat (3).
-
After feeding out the mat, replace it with a new one or attach the material while keeping it within the adhesive area of the mat.
The cutting mats used by this machine have been redeveloped with a different design, type, function, etc.
For details, refer to Important information about Mat.
Beslektede vanlige spørsmål
Hvis du trenger ytterligere hjelp, kan du ta kontakt med Brothers kundeservice:
Tilbakemelding om innhold
Du kan hjelpe oss å forbedre kundestøtten vår ved å gi tilbakemelding nedenfor.
Trinn 1: Hvordan synes du informasjonen på denne siden hjelper deg?
Trinn 2: Ønsker du å legge til noen kommentarer?
Merk at dette skjemaet kun benyttes for tilbakemeldinger.