RJ-3035B
![]() |
Veelgestelde vragen en probleemoplossing |
![](/g/b/img/product/rj3035beuk.jpg)
RJ-3035B
Datum: 29-10-2020 Nummer: faqp00100466_002
How to calibrate the Gap/Black Mark Sensor by directly operating the printer
-
The Gap Sensor(*) / Black Mark Sensor sensitivity should be calibrated when:
- A new printer is purchased
- Label media is changed
(*) Product specifications vary by region. For more information, see the Specification Sheet from the [Manuals] section of this website.
- Models not equipped with the Black Mark Sensor cannot be used with Die Cut Labels.
To calibrate the Gap/Black Mark Sensor:
- Turn off the printer.
-
Press and hold the Feed/Pause Button (
) and then turn on the printer.
-
Release the Feed/Pause button (
) when the printer's Status LED changes to (
) and starts blinking.
The LEDs will change as follows:(Orange) (5 times) -> Release the Feed/Pause button ( ) to enter calibration mode.
(5 times) (5 times) (Green (lit))
RJ-2035B, RJ-2055WB, RJ-3035B, RJ-3055WB
Heeft u meer hulp nodig, dan kunt u contact opnemen met de Brother-klantenservice.
Feedback
Geef hieronder uw feedback. Aan de hand daarvan kunnen wij onze ondersteuning verder verbeteren.
Stap 1: is de informatie op deze pagina nuttig voor u?
Stap 2: wilt u nog iets toevoegen?
Dit formulier is alleen bedoeld voor feedback.