CP2160W
![]() |
Preguntas frecuentes y solución de problemas |
![](/g/b/img/product/hf_cp2160weus.jpg)
CP2160W
Fecha: 31/05/2021 ID: faqh00101548_004
Machine does not start to sew.
If the machine does not start when you press the Foot controller, check the following possible causes and solutions.
-
The bobbin winder shaft is pushed to the right.
Slide the bobbin winder shaft to the left until it snaps into place.
Refer to "How do I wind the bobbin?".
-
Presser foot is not lowered.
Lower the presser foot.
Refer to "Basic procedure to sew stitches".
-
The foot controller was pressed with the buttonhole lever is down while a stitch other than a buttonhole stitch or a bar tack stitch is selected.
Raise the buttonhole lever before continuing the operation.(1) Buttonhole lever
-
The foot controller was pressed with the buttonhole lever is up while a buttonhole stitch or a bar tack stitch is selected.
Lower the buttonhole lever before continuing the operation.(1) Buttonhole lever
Preguntas frecuentes relacionadas
Si necesita asistencia, contáctese con el servicio al cliente de Brother:
Comentarios sobre el contenido
Para ayudarnos a mejorar el soporte, bríndenos sus comentarios a continuación.
Paso 1: ¿Cómo lo ayudó la información en esta página?
Paso 2: ¿Quiere agregar otros comentarios?
Observe que este formulario solo se utiliza para comentarios.