RJ-3055WB
FAQ et Diagnostic |
RJ-3055WB
Date: 29/10/2020 ID: faqp00100466_002
How to calibrate the Gap/Black Mark Sensor by directly operating the printer
-
The Gap Sensor(*) / Black Mark Sensor sensitivity should be calibrated when:
- A new printer is purchased
- Label media is changed
(*) Product specifications vary by region. For more information, see the Specification Sheet from the [Manuals] section of this website.
- Models not equipped with the Black Mark Sensor cannot be used with Die Cut Labels.
To calibrate the Gap/Black Mark Sensor:
- Turn off the printer.
- Press and hold the Feed/Pause Button ( ) and then turn on the printer.
-
Release the Feed/Pause button ( ) when the printer's Status LED changes to ( ) and starts blinking.
The LEDs will change as follows:(Orange) (5 times) -> Release the Feed/Pause button ( ) to enter calibration mode. (5 times) (5 times) (Green (lit))
RJ-2035B, RJ-2055WB, RJ-3035B, RJ-3055WB
Pour toute assistance supplémentaire, contactez le service clientèle de Brother:
Commentaires sur le contenu
Merci d'indiquer vos commentaires ci-dessous. Ils nous aideront à améliorer notre support.
Étape 1: Comment qualifieriez-vous les informations figurant sur cette page?
Étape 2: Y a-t-il des commentaires que vous voudriez ajouter?
Ce formulaire a pour seul but de nous faire part de vos commentaires.