PR655
FAQ et Diagnostic |
Date: 04/03/2009 ID: faqh00000320_000
Why does my thread keep jamming?
The thread could be jamming due to several reasons.
- The upper thread could be tangled. Remove the thread completely from the machine.
The correct size spool cap should be used for the size of the thread spool.
Re-thread the machine according to the directions in the manual.
One Point Advice Place a spool of thread on a spool pin
One Point Advice Upper threading
- Remove the bobbin and make sure the bobbin is threaded properly in the shuttle race.
Remove any loose threads or lint in the shuttle race.
One Point Advice When thread got tangled
One Point Advice Lower(bobbin) threading
- The tension could be too tight or too loose.
Set the tension to the best thread tension setting or adjust the tension manually.
- Needle and thread are incorrect. Be sure to use the correct thread and embroidery needle(s).
PR-600/600C, PR-620/620C/600II/600IIC, PR-650, PR650e, PR655
Pour toute assistance supplémentaire, contactez le service clientèle de Brother:
Commentaires sur le contenu
Merci d'indiquer vos commentaires ci-dessous. Ils nous aideront à améliorer notre support.
Étape 1: Comment qualifieriez-vous les informations figurant sur cette page?
Étape 2: Souhaitez-vous ajouter des commentaires?
Ce formulaire a pour seul but de nous faire part de vos commentaires.