HL-5050
FAQ et Diagnostic |
HL-5050
Date: 16/10/2006 ID: faq00000231_010
Printouts (envelopes) have creases.
Please do the following:
If envelops were creased after they have been printed, please take the following countermeasures:
- Firstly, please change a paper size setting to "DL Long Edge" at printer driver properties.
And then put in envelopes sideways, and print again.
- At the back of the printer, open the back output tray and push down the blue tabs at the left and right hand sides (as shown in the figure below). When you have finished printing your envelopes, close the back output tray to reset the two blue tabs back to their original position.
FAQ connexes
HL-5030, HL-5040, HL-5050, HL-5070N
Pour toute assistance supplémentaire, contactez le service clientèle de Brother:
Commentaires sur le contenu
Merci d'indiquer vos commentaires ci-dessous. Ils nous aideront à améliorer notre support.
Étape 1: Comment qualifieriez-vous les informations figurant sur cette page?
Étape 2: Y a-t-il des commentaires que vous voudriez ajouter?
Ce formulaire a pour seul but de nous faire part de vos commentaires.