HL-1650
 |
FAQs & Troubleshooting |
HL-1650
Date: 27/01/2014 ID: faq00000168_001
ERROR XX <-> SERVICE CALL
When any of the following messages appear on the LCD, turn the printer Off, wait 5 seconds and then turn the printer On again. If the alarm continues, perform a Factory Reset as follows:
- Press the - (minus) button until the screen says Reset Menu. The LCD should be amber.
- Press the Set button.
- Press the + (plus) or - (minus) button until the LCD says Factory Reset, press Set.
- The LCD will say OK? confirming your selection. Press the Set button.
-
The printer will automatically go to a green Ready on the LCD.
If this does not clear the problem, consult your dealer or our authorized service representative.
HL-1650, HL-1670N, HL-1850, HL-1870N
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.