RJ-3035B
![]() |
Ofte stillede spørgsmål og fejlfinding |
![](/g/b/img/product/rj3035beuk.jpg)
RJ-3035B
Dato: 29-10-2020 Id: faqp00100466_002
How to calibrate the Gap/Black Mark Sensor by directly operating the printer
-
The Gap Sensor(*) / Black Mark Sensor sensitivity should be calibrated when:
- A new printer is purchased
- Label media is changed
(*) Product specifications vary by region. For more information, see the Specification Sheet from the [Manuals] section of this website.
- Models not equipped with the Black Mark Sensor cannot be used with Die Cut Labels.
To calibrate the Gap/Black Mark Sensor:
- Turn off the printer.
-
Press and hold the Feed/Pause Button (
) and then turn on the printer.
-
Release the Feed/Pause button (
) when the printer's Status LED changes to (
) and starts blinking.
The LEDs will change as follows:(Orange) (5 times) -> Release the Feed/Pause button ( ) to enter calibration mode.
(5 times) (5 times) (Green (lit))
Kontakt Brother Support, hvis du har brug for yderligere hjælp:
Feedback til indhold
Giv feedback herunder, så vi kan forbedre vores support.
Trin 1: Hvor hjælpsom har oplysningerne på denne side været?
Trin 2: Ønsker du at tilføje kommentarer?
Bemærk, at denne formular kun bruges til feedback.