PR-650
Ofte stillede spørgsmål og fejlfinding |
PR-650
Dato: 04-03-2009 Id: faqh00000315_000
Why won't the machine pick up the bobbin thread?
There could be several things that could cause the machine not to pick up the bobbin thread.
- The upper thread could be tangled. Remove the thread completely from the machine.
The correct size spool cap should be used for the size of the thread spool. Re-thread the machine according to the directions in the manual.
One Point Advice Place a spool of thread on a spool pin
One Point Advice Upper threading
- Remove the bobbin and make sure the bobbin is threaded properly in the shuttle race.
Remove any loose threads or lint in the shuttle race.
One Point Advice Lower(bobbin) threading
- You could be holding the needle thread too tight. Hold the thread lightly to keep the end from going down into the shuttle.
- The needle could be thread incorrectly. Thread the needle eye from the front to the back.
- The needle could be bent or improperly inserted. Install a new needle with the flat side of the needle facing the back.
- The thread twist is either too tight or too loose. Improper twisting results in irregular loop formation. Try using a new spool.
Kontakt Brother Support, hvis du har brug for yderligere hjælp:
Feedback til indhold
Giv feedback herunder, så vi kan forbedre vores support.
Trin 1: Hvor hjælpsom har oplysningerne på denne side været?
Trin 2: Ønsker du at tilføje kommentarer?
Bemærk, at denne formular kun bruges til feedback.