CS10
![]() |
Ofte stillede spørgsmål og fejlfinding |
Dato: 22-04-2013 Id: faqh00000061_000
An "E3" message appears on the panel.
The buttonhole or bar tack stitch was selected and the foot controller (or the start/stop button was pressed if the foot controller is not connected) while the buttonhole lever is raised.
Lower the buttonhole lever before continuing the operation.
Each time a key pressed or an incorrect operation is performed, a beep is sounded.
- For a correct operation
One beep is sounded. - If an incorrect operation is performed
Two or four beeps are sounded. - If the machine locks up, for example, because the thread is tangled
The sewing machine continues to beep for four seconds.
The machine automatically stops.
Be sure to check for the cause of the error, and correct it before continuing to sew.
BC-2100/2300, BC-2500, CS10, DS-120, DS-140, FS100WT, FS-20, FS-40, Innov-is 150SE/ 150, Innov-is 200, Innov-is 27SE, Innov-is 30, Innov-is 35, KD40, KE20, NX-200
Kontakt Brother Support, hvis du har brug for yderligere hjælp:
Feedback til indhold
Giv feedback herunder, så vi kan forbedre vores support.
Trin 1: Hvor hjælpsom har oplysningerne på denne side været?
Trin 2: Ønsker du at tilføje kommentarer?
Bemærk, at denne formular kun bruges til feedback.