Ofte stillede spørgsmål og fejlfinding

Luk

DCP-L3517CDW

Ofte stillede spørgsmål og fejlfinding

Ofte stillede spørgsmål og fejlfinding

Dato: 28-11-2018 Id: faq00100268_002

Load Paper in the Paper Tray

  • If the Check Size setting is set to On and you pull the paper tray out of the machine, a message appears on the machine's display (hereinafter called LCD) asking if you want to change the paper size and paper type. Change the paper size and paper type settings if needed, following the LCD instructions.
  • When you load a different size and type of paper in the tray, you must also change the Paper Size and Paper Type settings in the machine, or on your computer.

NOTE: Illustrations shown below are from a representative product and may differ from your Brother machine.

 

  1. Pull the paper tray completely out of the machine.
    Pull the paper tray completely out
  2. Press and slide the paper guides to fit the paper.
    Press the green release levers to slide the paper guides.
    Slide the paper guides to fit the paper
  3. Fan the stack of paper well.
  4. Load paper in the paper tray with the printing surface face down.
  5. Make sure the paper is below the maximum paper mark maximum paper mark.
    Overfilling the paper tray will cause paper jams.
    Make sure the paper is below the maximum paper mark
  6. Slowly push the paper tray completely into the machine.
  7. Lift the support flap to prevent paper from sliding off the output tray.
    Lift the support flap

Relaterede ofte stillede spørgsmål

Kontakt Brother Support, hvis du har brug for yderligere hjælp:

Feedback til indhold

Giv feedback herunder, så vi kan forbedre vores support.
Trin 1: Hvor hjælpsom har oplysningerne på denne side været?
Trin 2: Ønsker du at tilføje kommentarer?

Bemærk, at denne formular kun bruges til feedback.