Ofte stillede spørgsmål og fejlfinding

Luk

HL-3170CDW

Ofte stillede spørgsmål og fejlfinding

Ofte stillede spørgsmål og fejlfinding

HL-3170CDW

Er det ikke dit produkt?

Dato: 08-11-2018 Id: faq00002192_007

I configured the "IP Config" method of the machine to "Auto" to assign an IP address automatically, however it was changed to "Static" unexpectedly. I get an error message that indicates IP address is not unique, or a document is printed out by the machine I didn't expect.

When wireless network connection is unstable and the APIPA protocol is enabled, you might experience this difficulty.

Please follow these steps below to set the BOOT method back to AUTO and disable the APIPA protocol.

 

  1. Make sure that the power cord is plugged in.
  2. Turn on the printer and wait until the printer is in the Ready state.
  3. Press the Up or Down arrow key to select Network, and press OK.
  4. Press the Up or Down arrow key to select WLAN, and press OK.
    (NOTE: If your machine supports only wireless network, skip this step.)
  5. Press the Up or Down arrow key to select TCP/IP, and press OK.
  6. Press the Up or Down arrow key to select Boot Method, and press OK.
  7. Press the Up or Down arrow key to select Auto, and press OK.
  8. Press the Up or Down arrow key to select APIPA, and press OK.
  9. Press the Up or Down arrow key to select Off, and press OK.
  10. Press Cancel.

Relaterede ofte stillede spørgsmål

Kontakt Brother Support, hvis du har brug for yderligere hjælp:

Feedback til indhold

Giv feedback herunder, så vi kan forbedre vores support.
Trin 1: Hvor hjælpsom har oplysningerne på denne side været?
Trin 2: Ønsker du at tilføje kommentarer?

Bemærk, at denne formular kun bruges til feedback.

Indsend