DS-140
Nejčastější dotazy a pokyny pro odstraňování potíží |
DS-140
Datum: 25/02/2009 ID: faqh00000018_000
Why won't the machine pick up the bobbin thread?
There could be several things that could cause the machine not to pick up the bobbin thread.
- The upper thread could be tangled.
Remove the thread completely from the machine.
The correct size spool cap should be used for the size of the thread spool.
Re-thread the machine according to the directions in the manual.
One Point Advice Place a spool of thread on a spool pin.
One Point Advice Upper threading
- Remove the bobbin and make sure the bobbin is threaded properly in the shuttle race.
Remove any loose threads or lint in the shuttle race.
One Point Advice Installing a bobbin into a bobbin case
- You could be holding the needle thread too tight.
Hold the thread lightly to keep the end from going down into the shuttle.
- The needle could be thread incorrectly.
Thread the needle eye from the front to the back.
- The needle could be bent or improperly inserted.
Install a new needle with the flat side of the needle facing the back.
Související nejčastější dotazy
Potřebujete-li další pomoc, kontaktujte zákaznický servis společnosti Brother:
Názory na obsah
Chcete-li nám pomoci vylepšit naši podporu, uveďte níže vaše názory.
Krok 1: Jak vám informace na této stránce pomohly?
Krok 2: Chcete uvést další poznámky?
Upozorňujeme vás, že tento formulář slouží pouze pro názory.