Printer initialization clears the printer's DRAM and restores its factory settings.

1. Turn off the printer.


2. Press and hold the right Selection button, and then turn on the Power Switch.


3. Release the button when Factory Default appears on the screen.

   You can also release the button when the LED is flashing in green (5 times).
   The LED color will change in the following order:

   Amber > red (5 times) > amber (5 times) > green (5 times) > green/amber (5 times) > red/amber (5 times) > green (lit)

   After the initialization, the following factory settings will be restored:

   Parameter	Default setting
   Speed	152.4 mm/sec (6 ips) (203 DPI) 101.4 mm/sec (4 ips) (300 DPI) 76.2 mm/sec (3 ips) (600 DPI)
   Density	8
   Label Width	101.5 mm (4")
   Label Height	101.5 mm (4")
   Sensor Type	Gap sensor
   Gap Setting	3 mm (0.12")
   Print Direction	0
   Reference Point	0,0 (upper left corner)
   Offset	0
   Tear Mode	On
   Peeler Mode	Off
   Cutter Mode	Off
   Rewinder Mode	Off
   Code Page	850
   Country Code	001
   Clear Flash Memory	No