Perform the region emboss initial setting according to the following procedure.


Prepare the following.

Paper	Adjustment sheet for region embossing　(included in the box)
Mat	Low Tack Adhesive Mat
Blade	Auto Blade (Black)

1. Select Region Emboss on page 2 of the Home screen.
   
   

   
   
   
    
2. Press the Create template to perform the region emboss initial setting .
   
   
   
   
   
    
3. Press OK key.
   You can also follow the on-screen instructions.
   
   
   
   
   
    
4. Attach the Adjustment sheet to the low tack adhesive mat.
   Make sure that the printed side is facing up and the arrow and black bar in first when attaching the sheet to the mat.
   
   
   
   
    
5. Install the auto blade holder into the carriage of the machine.
   
   
   
   
    
6. Load the mat into the machine.
   
   
   
   
   
    
7. Press Start key to start cutting.
   
   
   
   
   
   
    
8. Press OK key when the cutting is finished.
   
   
   
   
   
   
    
9. Press   to upload the mat, and then peel off the material from the mat.
   
   
   
   
    
10. Fold the Adjustment Sheet in half along the dotted line as shown the following illustration.
    
    
    
    
    
     
11. Overlap .
    Referring to the numbers below the rectangles, press  or  to enter the number for the cutout that is perfectly aligned on the left and right.
    
    
    
    
    
    
     
12. Press the OK key.
    
    
    
    
     
13. Press the OK key.
    
    
    >> The region emboss initial setting is finished.
    Continue to perform region embossing referring to the Instruction Manual for Embossing Starter Kit.

    Refer to What should I do if I want to change the initial setting  (position adjustment) for region embossing? if you want to change the setting.

▲TOP