CM600
 |
FAQ et Diagnostic |
Date: 10.07.2017 ID: faqh00000699_000
The material to be cut/drawn or original to be scanned peels off during cutting/scanning.
Possible Causes (or Results)
- The mat’s adhesive strength has decreased, or the material is not secured.
-
The material extends from the adhesive area of the mat.
Solutions
-
Press the “Start/Stop” button to stop the operation.
-
Follow the instructions on the screen, and press the “Feed” button
to feed out the mat.
If the mat does not feed out, turn off the machine (1), remove the holder (2), and then manually feed out the mat (3).
-
After feeding out the mat, replace it with a new one or attach the material while keeping it within the adhesive area of the mat.
The cutting mats used by this machine have been redeveloped with a different design, type, function, etc.
For details, refer to Important information about Mat.
FAQ connexes
CM260, CM300, CM600, CM700, CM750, CM840, CM900
Pour toute assistance supplémentaire, contactez le service clientèle de Brother:
Commentaires sur le contenu
Merci d'indiquer vos commentaires ci-dessous. Ils nous aideront à améliorer notre support.
Étape 1: Comment qualifieriez-vous les informations figurant sur cette page?
Étape 2: Souhaitez-vous ajouter des commentaires?
Ce formulaire a pour seul but de nous faire part de vos commentaires.