PR655
![]() |
FAQ et Diagnostic |
Date: 04.03.2009 ID: faqh00000315_000
Why won't the machine pick up the bobbin thread?
There could be several things that could cause the machine not to pick up the bobbin thread.
- The upper thread could be tangled. Remove the thread completely from the machine.
The correct size spool cap should be used for the size of the thread spool. Re-thread the machine according to the directions in the manual.
One Point Advice Place a spool of thread on a spool pin
One Point Advice Upper threading
- Remove the bobbin and make sure the bobbin is threaded properly in the shuttle race.
Remove any loose threads or lint in the shuttle race.
One Point Advice Lower(bobbin) threading
- You could be holding the needle thread too tight. Hold the thread lightly to keep the end from going down into the shuttle.
- The needle could be thread incorrectly. Thread the needle eye from the front to the back.
- The needle could be bent or improperly inserted. Install a new needle with the flat side of the needle facing the back.
- The thread twist is either too tight or too loose. Improper twisting results in irregular loop formation. Try using a new spool.
Pour toute assistance supplémentaire, contactez le service clientèle de Brother:
Commentaires sur le contenu
Merci d'indiquer vos commentaires ci-dessous. Ils nous aideront à améliorer notre support.
Étape 1: Comment qualifieriez-vous les informations figurant sur cette page?
Étape 2: Souhaitez-vous ajouter des commentaires?
Ce formulaire a pour seul but de nous faire part de vos commentaires.