DCP-L6600DW
 |
ЧЗВ и отстраняване на неизправности |
DCP-L6600DW
Дата: 13/04/2016 Идентификационен номер: faq00100269_502
Load Thick Paper in the Paper Tray
If the Check Size setting is set to On and you pull the paper tray out of the machine, a message appears on the LCD asking if you want to change the paper size and paper type. Change the paper size and paper type settings if needed, following the LCD instructions.
- When you load a different size and type of paper in the tray, you must change the Paper Size and Paper Type settings in the machine or on your computer, also.
- Pull the paper tray completely out of the machine.
- Press and slide the paper guides to fit the paper.Press the green release levers to slide the paper guides.
- Fan the stack of paper well.
- Load paper in the paper tray with the printing surface face down.
DO NOT load different sizes and types of paper in the paper tray at the same time. Doing this may cause the paper to jam or misfeed.
- Make sure the paper is below the maximum paper mark (
). Overfilling the paper tray will cause paper jams.
- Slowly push the paper tray completely into the machine.
- Open the machine's back cover (the face up output tray).
- Open the paper stopper (Available only for certain models).
- Send your print job to the machine.Change your print preferences in the Print dialog box before sending the print job from your computer.
- Close the paper stopper (Available only for certain models).
- Close the back cover (the face up output tray) until it locks in the closed position.
Свързани ЧЗВ
DCP-L5500DN, DCP-L6600DW, MFC-L5700DN, MFC-L5750DW, MFC-L6800DW(T), MFC-L6900DW(T)
Ако ви е необходимо допълнително съдействие, моля, свържете се с центъра за клиенти на Brother:
Обратна връзка за съдържанието
За да ни помогнете да подобрим нашата поддръжка, моля, оставете вашата обратна връзка по-долу.
Стъпка 1: Как ви помага информацията на тази страница?
Стъпка 2: Искате ли да добавите коментар?
Имайте предвид, че този формуляр се използва само за обратна връзка.