FAQs & Troubleshooting
![]() |
Popular |
292 Results
- 1Can I create the cutting data for ScanNCut from the image data?
- 2Mat and Material Combinations
- 3Scanning a Background Image (Background Scanning).
- 4What should I do if the scanned and cut positions are misaligned?
- 5What type of data can my ScanNCut machine be used?
- 6Adjusting the Blade Extension
- 7The mat is fed in at an angle and is not fed during cutting / drawing.
- 8Cut a thin fabric for the quilt piece. (How to use the High Tack Adhesive Fabric Support Sheet.)
- 9About Blade Extension, Cutting Pressure and Mat
- 10Cutting/Drawing by Tracing an Image
- 11There are deep cuts completely through the mat.
- 12Downloading Optional Design Pattern Collection
- 13Cut the fabric other than quilt pieces. (How to use the Iron-On Fabric Appliqué Contact Sheet.)
- 14Mat and Cutting Blade Combinations
- 15ErrS99 appears on the computer screen.
- 16I adjust the blade extension and the cut pressure to the setting described in the Quick Reference Guide. But the result of cutting the material was not good.
- 17ErrS52 appears on the computer screen.
- 18How to Use the Printable Sticker Function on CanvasWorkspace for PC [Video]
- 19List of Error Messages for CanvasWorkspace (Exxxxx / Nxxxxx)
- 20The 12" × 24" (305 mm × 610 mm) mat cannot be used with scanning function.
- 21Replacing the Blade
- 22Preparation of Craft Paper / Fabric
- 23ErrS09 appears on the computer screen.
- 24ErrS01 appears on the computer screen.
- 25E10006 appears on the computer screen.
- 26E02006 appears on the computer screen.
- 27E02005 appears on the computer screen.
- 28Can the Cutting mat or Scanning mat for the ScanNCut (CM series) be used in the ScanNCut DX (SDX series)?
- 29N11001 appears on the computer screen.
- 30E01001 appears on the computer screen.
- 31List of Error Messages
- 32When I created a cutting data scanning my illustration, some areas were not converted to the cutting lines.
- 33How long will the mat last?
- 34How do I Create the Cutting Data (Scan to Cut Data) [Video]
- 35How do I Scan for Cutting (Direct Cut) ?
- 36Attaching & Peeling Off the Material
- 37What should I do if I want to change the initial setting (position adjustment) for region embossing?
- 38Can I create the cutting data for ScanNCut from vector graphics data?
- 39List of Error Messages for CanvasWorkspace (Others)
- 40List of Error Messages for CanvasWorkspace (ErrSxx / NoteSxx)
- 41ErrS25 appears on the computer screen.
- 42ErrS23 appears on the computer screen.
- 43ErrS10 appears on the computer screen.
- 44ErrS08 appears on the computer screen.
- 45ErrS07 appears on the computer screen.
- 46ErrS04 appears on the computer screen.
- 47The Pattern for Paper Piercing or The Paper Piercing Menu Is Not Displayed.
- 48What is the Difference between "Pen Holder", "Universal Pen Holder" and "Small Barrel Pan Holder"?
- 49Can multiple sheets of material be overlapped and attached to the mat?
- 50How to Import My Project to CanvasWorkspace [Video]