CM600
Veelgestelde vragen en probleemoplossing |
9 Resultaten
Sorteren op
- 110-07-2017Not all of the material to be cut is cut. Some areas remain uncut.
- 210-07-2017The material to be cut/drawn or original to be scanned peels off during cutting/scanning.
- 310-07-2017The mat is fed in at an angle and is not fed during cutting / drawing.
- 410-07-2017The mat or the material catches on a feed roller during cutting/drawing.
- 509-06-2017I adjust the blade extension and the cut pressure to the setting described in the Quick Reference Guide. But the result of cutting the material was not good.
- 616-01-2017What should I do if the entire pattern is not cut?
- 716-01-2017What should I do if part of the material is not cut?
- 808-08-2016What should I do if the scanned and cut positions are misaligned?
- 919-08-2015There are deep cuts completely through the mat.