CM350
FAQ et Diagnostic |
9 Résultats
Trier par
- 12017-07-10Not all of the material to be cut is cut. Some areas remain uncut.
- 22017-07-10The material to be cut/drawn or original to be scanned peels off during cutting/scanning.
- 32017-07-10The mat is fed in at an angle and is not fed during cutting / drawing.
- 42017-07-10The mat or the material catches on a feed roller during cutting/drawing.
- 52017-06-09I adjust the blade extension and the cut pressure to the setting described in the Quick Reference Guide. But the result of cutting the material was not good.
- 62017-01-16What should I do if the entire pattern is not cut?
- 72017-01-16What should I do if part of the material is not cut?
- 82016-08-08What should I do if the scanned and cut positions are misaligned?
- 92015-08-19There are deep cuts completely through the mat.