TD-4750TNWB

FAQs & Troubleshooting

FAQs & Troubleshooting

How do I clean / maintain my printer?

> Clean the Sensors
> Clean the Tear Bar/ Peel Bar
> Clean the Exterior/ Interior
 

Clean the Sensors

 

  1. Turn off the printer.

  2. Press the tabs on both sides of the printer, and then lift the Roll Compartment Cover.
    Open cover

  3. Use compressed air or vacuum to clean the Gap Sensor (1) and Black Mark Sensor (2).
    Clean sensors
    1.  Gap Sensor
    2.  Black Mark Sensor

    We recommend cleaning the sensors once per month.

 

Clean the Tear Bar/ Peel Bar


  1. Press the tabs on both sides of the printer, and then lift the Roll Compartment Cover.
    Open cover

  2. Wipe the Tear Bar (1)  and the Peel Bar (2) with a lint-free cloth dipped in isopropyl alcohol or ethanol, as needed.
    Wipe Tear/Peel Bar
     1. Tear Bar
     2. Peel Bar

 

Clean the Exterior/ Interior


Exterior: Wipe with a lint-free cloth dipped in water, as needed.
Interior: Use a brush or vacuum, as needed.

If your question was not answered, have you checked other FAQs?

Have you checked manuals?

If you need further assistance, please contact Brother customer service:

Related Models

TD-4650TNWB, TD-4750TNWB

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: €Are there any comments you would like to add?

Please note this form is used for feedback only.