SDX125TS
 |
Preguntas frecuentes y solución de problemas |
The mat is fed in at an angle.
Possible Causes (or Results)
| Case1 : |
The mat was inserted into the feed slot at an angle. |
| Case2 : |
The corners of the mat are deformed (bent). |
| Case3 : |
The rear tray is not pulled out. |
| Case4 : |
The feed roller is not positioned correctly. |
| Case5 : |
The shaft is released. |
Solutions
----- Case1 -----
Press the 
(Feed) button to feed out the mat.
Re-insert the mat straight in.
----- Case2 -----
Replace the mat with a new one.
----- Case3 -----
Pull out the rear tray.
----- Case4 -----
Adjust the position of the feed roller.
For details, refer to Adjusting the Position of the Feed Roller
----- Case5 -----
Lock the shaft.
Si no obtuvo una respuesta, ¿ha revisado otras preguntas frecuentes?
¿Ha revisado los manuales?
Si necesita asistencia, contáctese con el servicio al cliente de Brother:
Modelos relacionados
SDX125, SDX125e, SDX125e Titanium, SDX125i, SDX125TS, SDX135PRO, SDX225, SDX225F, SDX230D, SDX230Di, SDX230DX, SDX325, SDX330D, SDX85, SDX85C, SDX85M, SDX85S
Comentarios sobre el contenido
Para ayudarnos a mejorar el soporte, bríndenos sus comentarios a continuación.
