Model discontinued. This page is no longer updated.

HL-3260N

FAQs & Troubleshooting

FAQs & Troubleshooting

How do I add the Staples?

When the message "Add Staples" appears on the Control panel, the staples have run out.


Follows these steps to add a new staple refill.

 

After adding the Staple refill, Staples might not be ejected for the first few times.

 
  1. Open the Rear cover of the Finisher.

     

  2. Remove the empty cartridge.

     

  3. Remove the empty refill case as shown in the illustration.

     

  4. Align the arrows on the new refill case and the cartridge, and push the new refill case in until it clicks.

     

    Do not remove the ribbon securing the staples before installing the cartridge.

     
  5. Pull out the ribbon securing the Staples.

     

  6. Reinstall the cartridge. It should click into place.

     

  7. Close the Front cover of the Finisher.
 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

HL-3260N

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: €Are there any comments you would like to add?

Please note this form is used for feedback only.