TJ-4420TN
![Vanliga frågor & felsökning Vanliga frågor & felsökning](/g/b/shared/img/module/icon_question_33.png) |
Vanliga frågor & felsökning |
How to reset the printer settings by directly operating the printer
Printer initialization clears the printer's DRAM and restores its factory settings.
-
Turn off the printer.
-
Press and hold the right Selection button, and then turn on the Power Switch.
-
Release the button when Factory Default appears on the screen.
You can also release the button when the LED is flashing in green (5 times).
The LED color will change in the following order:
Amber > red (5 times) > amber (5 times) > green (5 times) > green/amber (5 times) > red/amber (5 times) > green (lit)
After the initialization, the following factory settings will be restored:
Parameter |
Default setting |
Speed |
152.4 mm/sec (6 ips) (203 DPI)
101.4 mm/sec (4 ips) (300 DPI)
76.2 mm/sec (3 ips) (600 DPI) |
Density |
8 |
Label Width |
101.5 mm (4") |
Label Height |
101.5 mm (4") |
Sensor Type |
Gap sensor |
Gap Setting |
3 mm (0.12") |
Print Direction |
0 |
Reference Point |
0,0 (upper left corner) |
Offset |
0 |
Tear Mode |
On |
Peeler Mode |
Off |
Cutter Mode |
Off |
Rewinder Mode |
Off |
Code Page |
850 |
Country Code |
001 |
Clear Flash Memory |
No |
Om du inte fick svar på din fråga, har du tittat på andra Vanliga frågor?
Har du tittat efter i manualerna?
Om du behöver mer hjälp kontaktar du Brothers kundtjänst:
Feedback om innehållet
Hjälp oss att göra vår support bättre genom att lämna din feedback nedan.