TD-4750TNWBR

Vanliga frågor & felsökning

Printing the printer configuration (Self-test)

Print the printer configuration after you run Gap/Black Mark Sensor calibration. (To print the Self-test printouts, see the FAQ: "How to execute the printer configuration (Self-test) to debug".)

The self-test printout lists the printer's configuration and available memory, and can indicate if there is any dot damage on the heater component.

Self-test printout

	1. Model name 2. Firmware version 3. Firmware checksum 4. Printer Serial number 5. Configuration file 6. System date 7. System time 8. Printed mileage (meter) 9. Cutting counter 10. Number of defective dots
	1. Print speed (inch/sec) 2. Print density 3. Label size (inch) 4. Gap distance (inch) 5. Gap/Black Mark Sensor sensitivity 6. Code page 7. Country code
	ZPL setting information 1. Print darkness 2. Print speed (inch/sec) 3. Label size 4. Control prefix 5. Format prefix 6. Delimiter prefix 7. Printer power up motion 8. Printer head close motion ZPL is emulating for Zebra® language.
	RS232 Serial Port configuration
	Bluetooth^® configuration
	Country of RFID frequency band
	1．Printer name 2．Mac Address 3．DHCP 4．IP Address 5．Subnet Mask 6．Gateway 7．RAW Port
	Wi-Fi® configuration
	1. Numbers of downloaded files Total and available memory space 2. Print Head check pattern