HL-L2300D
 |
Odpowiedzi na często zadawane pytania i rozwiązywanie problemów |
Clean the drum unit
If your printout has dots or other repeating marks at 94 mm (3.7 in.) intervals, the drum may have foreign material, such as glue from a label stuck on the drum surface. Follow the steps below to clean the drum unit.
-
Open the front cover.
-
Remove the toner cartridge and drum unit assembly from the machine.
-
Push down the green lock lever and take the toner cartridge out of the drum unit.
-
Turn the drum unit as shown in the illustration. Make sure that the drum unit gear is on the left side.
-
Turn the edge of the drum unit toward you by hand while looking at surface of the suspected area.
-
Wipe the surface of the drum gently with a dry cotton swab until the mark on the surface comes off.
-
Put the toner cartridge firmly into the drum unit until you hear it lock into place.
-
Install the toner cartridge and drum unit assembly back into the machine.
- Close the front cover of the machine.
Jeśli Twoje pytanie pozostaje bez odpowiedzi, czy sprawdziłaś/sprawdziłeś inne odpowiedzi na często zadawane pytania?
Opinie dotyczące treści
Aby pomóc nam udoskonalać naszą pomoc techniczną, przekaż poniżej swoją opinię.
