The half cut is either too deep or not deep enough.
You can adjust how deep a half cut is cut with laminated tape, for example, when the tape is cut too much or not enough. Normally, it is only necessary to change the setting by one. If the half cut is still either too deep or not deep enough, change the setting by one again.
Hold down the Code key and press the 'A' key.
Press the Left Arrow or Right Arrowkey until "HALF CUTTER" is displayed.
Press the Up Arrowor Down Arrowkey until the desired setting is displayed.
To cut less deep, select a lower value. To cut deeper, select a higher value.
Adjust the setting in small steps.
Press the Return/New Block key to apply the setting.
If the tape is still not cut correctly even after this setting has been continuously adjusted, the cutter may be dull. Contact the sales outlet where the printer was purchased.
Si no obtuvo una respuesta, ¿ha revisado otras preguntas frecuentes?
