CM350e
|
Preguntas frecuentes y solución de problemas |
What should I do if part of the material is not cut?
If part of the material is not cut, the cutting pressure may not be set appropriately for the material.
Increase the cutting pressure by 1, and then perform trial cutting.
When the blade is strongly pressed against the material, the material may lift off the mat. If you adjust the cutting pressure, increase by 1.
Si no obtuvo una respuesta, ¿ha revisado otras preguntas frecuentes?
¿Ha revisado los manuales?
Si necesita asistencia, contáctese con el servicio al cliente de Brother:
Modelos relacionados
CM300, CM350e, CM550DX/ CM550, CM650W
Comentarios sobre el contenido
Para ayudarnos a mejorar el soporte, bríndenos sus comentarios a continuación.