FS-40
 |
FAQ et Diagnostic |
Why won't the machine pick up the bobbin thread?
There could be several things that could cause the machine not to pick up the bobbin thread.
- The upper thread could be tangled.
Remove the thread completely from the machine.
The correct size spool cap should be used for the size of the thread spool.
Re-thread the machine according to the directions in the manual.
One Point Advice Place a spool of thread on a spool pin.
One Point Advice Upper threading
- Remove the bobbin and make sure the bobbin is threaded properly in the shuttle race.
Remove any loose threads or lint in the shuttle race.
One Point Advice Installing a bobbin into a bobbin case
- You could be holding the needle thread too tight.
Hold the thread lightly to keep the end from going down into the shuttle.
- The needle could be thread incorrectly.
Thread the needle eye from the front to the back.
- The needle could be bent or improperly inserted.
Install a new needle with the flat side of the needle facing the back.
Si vous n'avez pas obtenu de réponse satisfaisante à votre question, avez-vous vérifié d'autres FAQ?
Modèles apparentés
BC-2100/2300, BC-2500, BM-3500/2600, CS10, CS120WT, CS70, CX70PE, DS-120, DS-140, ES-2000, FS100WT, FS-20, FS-40, FS60, FS60s, FS70WT, FS70WTs, JS23, KD40, KE20, LS-1217, LS-1520, LS-1717, PX-100/200/300, XL-2120/2220/2230, XL-2600/2610/2620, XL-3500/ 3510/3520, XL-3600, XL-5010/5020/5030, XL-5050/5060/5070
Commentaires sur le contenu
Merci d'indiquer vos commentaires ci-dessous. Ils nous aideront à améliorer notre support.
