CS10s
![FAQ et Diagnostic FAQ et Diagnostic](/g/b/shared/img/module/icon_question_33.png) |
FAQ et Diagnostic |
Machine does not start to sew.
If the machine does not start when you press the Foot controller, check the following possible causes and solutions.
-
The bobbin winder shaft is pushed to the right.
Slide the bobbin winder shaft to the left until it snaps into place.
![img01 img01](/g/b/img/faqend/faqh00101548_004/eu_ot/en/2412662/faqh1548_fig0301.gif)
Refer to "How do I wind the bobbin?".
-
Presser foot is not lowered.
Lower the presser foot.
![img02 img02](/g/b/img/faqend/faqh00101548_004/eu_ot/en/2412659/faqh1548_fig0302.gif)
Refer to "Basic procedure to sew stitches".
-
The foot controller was pressed with the buttonhole lever is down while a stitch other than a buttonhole stitch or a bar tack stitch is selected.
Raise the buttonhole lever before continuing the operation.
![img03 img03](/g/b/img/faqend/faqh00101548_004/eu_ot/en/2412660/faqh1548_fig0303.gif) |
(1) Buttonhole lever |
-
The foot controller was pressed with the buttonhole lever is up while a buttonhole stitch or a bar tack stitch is selected.
Lower the buttonhole lever before continuing the operation.
![img04 img04](/g/b/img/faqend/faqh00101548_004/eu_ot/en/2412661/faqh1548_fig0304.gif) |
(1) Buttonhole lever |
Si vous n'avez pas obtenu de réponse satisfaisante à votre question, avez-vous vérifié d'autres FAQ?
Avez-vous consulté les manuels?
Pour toute assistance supplémentaire, contactez le service clientèle de Brother:
Commentaires sur le contenu
Merci d'indiquer vos commentaires ci-dessous. Ils nous aideront à améliorer notre support.