PT-H105

FAQs & Troubleshooting

FAQs & Troubleshooting

How do I set tape margins and what features are they?

  1. Press the [Menu] key.

  2. Press the [Cursor] key to select [Margin] and press Enter key.

  3. Press the [Cursor] key to select the margin you wish among [Full/ Half/ Narrow/ Chain Print].

  4. Press Enter key.

 

<Full / Half / Narrow>

For leaving equal margins on both sides of the text.

The margin length are as follows:

Full - Half - Narrow

 

<Chain Print>

For creating a label containing text in various styles.

 

  1. Enter text.

  2. Press Print key, then [Copies:] appears.

  3. Press the [Cursor] key or enter number with number keys to select the number of copies.

  4. Press Enter key. Printing will start, and then the message [OK to Feed?] appears.

  5. Press Backspace key to enter more text.

  6. Clear the text, enter the text for the next label, and then press Print key.

  7. When the message [OK to Feed?] appears after the last label is printed, press Enter key.

  8. After the tape is fed, press the cutter lever to cut off the chain of labels.
  • When [Half] or [Narrow] is set, displayed label length is the length from the printed dots (:) to the end of the label.

  • To print more than 1 copy of a label with minimum margin, set the margin to [Narrow].

  • When [Chain Print] is set, feed the tape before using the cutter otherwise a part of the text may be cut off. Also, cut along the printed dots (:) with scissors so the text is centered in the label.
    *Feed the tape before using the cutter.

  • Do not pull the tape since this may damage the tape cassette.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

PT-H105

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: €Are there any comments you would like to add?

Please note this form is used for feedback only.