XL-2600/2610/2620

Ofte stillede spørgsmål og fejlfinding

Ofte stillede spørgsmål og fejlfinding
  • Dato: 07-04-2009
  • Id: faqh00000006_000

Place a spool of thread on a spool pin.

<Horizontal spool pin>
  1. Firmly hold the thread with a spool cap so that the thread does not turn too much.
    spool cap 1 Spool cap

    Make sure you use the correct size spool cap for the thread. If the spool cap is smaller the thread, tension may be incorrect.

  2. If you dont have a spool cap larger than the size of the thread, there is a slit in the thread spool.
    Slit(Notch) 1 Slit(Notch)

    Install the spoll so that the slit faces the base of the spool pin.

  3. It is important that the thread is pulled out from the spool smoothly. Make sure there is space around the spool cap and the tip of the spool pin for thread to pass through.
    Make sure there is space
<Vertical spool pin>
If a spool of thread turns too much and thread tension becomes improper, place a felt under the spool of thread.
place felt under the spool of thread 1 Felt

2 Spool pin

Har du læst andre ofte stillede spørgsmål, hvis dit spørgsmål ikke blev besvaret?

Har du set i manualerne?

Kontakt Brother Support, hvis du har brug for yderligere hjælp:

Relaterede modeller

BC-2100/2300, BC-2500, CS10, CS-8120, DS-120, DS-140, FS100WT, FS-20, FS-40, Innov-is 10/10A, Innov-is 1200, Innov-is 1250, Innov-is 15, Innov-is 1500D/1500, Innov-is 150SE/ 150, Innov-is 200, Innov-is 2200, Innov-is 27SE, Innov-is 30, Innov-is 35, Innov-is 350SE, Innov-is 400, Innov-is 4000D/4000, Innov-is 50, Innov-is 5000, Innov-is 500D, Innov-is 55, Innov-is 550SE/ 550, Innov-is 55FE, Innov-is 600, Innov-is 750E, Innov-is 900, Innov-is 950, Innov-is I, Innov-is Ie, KD40, KE20, NX-200, NX-2000, NX-400Q/400, NX-600, PE-300S, QC-1000, SuperGalaxie 3000/3000C/3000D/3100D, XL-2600/2610/2620

Feedback til indhold

Giv feedback herunder, så vi kan forbedre vores support.

Trin 1: Hvor hjælpsom har oplysningerne på denne side været?

Trin 2: Ønsker du at tilføje kommentarer?

Bemærk, at denne formular kun bruges til feedback.

Indsend