Innov-is F410
 |
Ofte stillede spørgsmål og fejlfinding |
"E08" message appears on the LCD. What does it mean?
Cause
This message is displayed when the Start/Stop button is pressed while the machine is set for the stitch width control.
Solution
Use the foot controller to operate the machine or turn off the width control function.
If you want to operate the machine with Start/Stop button, turn off the Width control function as follows.
-
When the width control function is enabled, the
mark is displayed on the LCD screen as shown in the figure below.
-
To disable the width control function, press the width control key
on the operation panel.
-
The
mark on the LCD screen disappears and the width control function turn off.
- Operation panel and operation keys vary depending on your machine model.
- The page numbers vary depending on your machine model.
Feedback til indhold
Giv feedback herunder, så vi kan forbedre vores support.
