When the bobbin begins to run out of thread during embroidering, this message appears on the display.
If the pattern is nearly complete at this time, you can finish the pattern safely without changing the bobbin thread.
Otherwise, you need to stop the machine and change bobbin thread. Replace bobbin thread as described below.

1. Press the Start/Stop button to stop the machine.
   
   
2. Press the Needle Position button to raise the needle, and raise the presser foot lever.
   
   
3. Use scissors to cut the upper thread.
   
   
4. Remove the embroidery frame.
   
   
   • Be careful not to apply strong force to the fabric at this time. Otherwise, the fabric may loosen in the frame.
   • Be careful not to bump the embroidery unit carriage or the presser foot when removing or attaching the embroidery frame. Otherwise, the pattern will not embroider correctly.
   
   
5. Insert a wound bobbin into the machine, then reattach the embroidery frame.
   
   
6. To return to the spot in the pattern where you stopped sewing, press key.
    
   
   
7. Press key to move the needle back 2-3 stitches before the spot where the thread was cut.
    
   
   
8. Press key to return to the original screen.
   
   
9. Lower the presser foot lever, and press the Start/Stop button to continue sewing.