Innov-is 500D

Ofte stillede spørgsmål og fejlfinding

Ofte stillede spørgsmål og fejlfinding
  • Dato: 25-02-2009
  • Id: faqh00000012_000

The thread is looping when I try to wind a bobbin.

Looping while winding the bobbin could be caused by several reasons.

 


  • The thread may not be threaded through the thread guide properly.
    Rethread guide following the diagram on the machine.
    Be sure to pass the thread as far as possible into the two slits in the thread guide.
    Be sure to pass the thread as far as possible into the two slits in the thread guide.
    1 Thread guide for bobbin winding
    2 Two slits
  • The bobbin winder cover may not be pushed all the way open. When opening the bobbin winder cover, make sure it is push open as far as it will go.
    When opening the bobbin winder cover, make sure it is push open as far as it will go.
  • The thread could be winding off to quickly. When using threads such as transparent nylon thread or metallic threads, place the spool net over the spool before placing the spool of thread onto the spool pin.
    Place the spool net over the spool before placing the spool of thread onto the spool pin. 1 Spool net
    2 Spool
    3 Spool pin
    4 Spool cap

Har du læst andre ofte stillede spørgsmål, hvis dit spørgsmål ikke blev besvaret?

Har du set i manualerne?

Kontakt Brother Support, hvis du har brug for yderligere hjælp:

Relaterede modeller

CS-8120, Innov-is 500D

Feedback til indhold

Giv feedback herunder, så vi kan forbedre vores support.

Trin 1: Hvor hjælpsom har oplysningerne på denne side været?

Trin 2: Ønsker du at tilføje kommentarer?

Bemærk, at denne formular kun bruges til feedback.

Indsend