How do I install/change the label roll?

To install a new label roll:

 

  1. Make sure that the printer is turned off. Hold the DK Roll compartment cover at the front of the printer and firmly lift it up to open the cover.
    Open cover
     
  2. Remove the protection sheet (1) of printing unit.
    Remove the protection sheet
  3. Put the spool into the spool guides in the DK Roll compartment.
    • Make sure that the spool arms (1) are inserted firmly in the spool guides (2) on the left and right.
    • Insert the spool with the DK Roll located on the right side of the printer.
    Put the spool
  4. Thread the end of the DK Roll into the slot until it aligns to the area shown below.

    Align the end of the roll with the upright edge of the label output slot.

  5. Close the DK Roll compartment cover.
    Close cover

 

To remove a label roll:

 

  1. Press the ON/OFF button to turn the printer off. Hold the DK Roll compartment cover at the front of the printer and firmly lift it up.
     
  2. Hold the label roll by the spool arms and pull the inserted DK Roll up.
     
  3. Close the DK Roll compartment cover.

Si vous n'avez pas obtenu de réponse satisfaisante à votre question, avez-vous vérifié d'autres FAQ?

Avez-vous consulté les manuels?

Pour toute assistance supplémentaire, contactez le service clientèle de Brother:

Modèles apparentés

QL-570, QL-580N

Commentaires sur le contenu

Merci d'indiquer vos commentaires ci-dessous. Ils nous aideront à améliorer notre support.

Étape 1: Comment qualifieriez-vous les informations figurant sur cette page?

Étape 2: Y a-t-il des commentaires que vous voudriez ajouter?

Ce formulaire a pour seul but de nous faire part de vos commentaires.