CM600
|
FAQ et Diagnostic |
What should I do if part of the material is not cut?
If part of the material is not cut, the cutting pressure may not be set appropriately for the material.
Increase the cutting pressure by 1, and then perform trial cutting.
When the blade is strongly pressed against the material, the material may lift off the mat. If you adjust the cutting pressure, increase by 1.
Si vous n'avez pas obtenu de réponse satisfaisante à votre question, avez-vous vérifié d'autres FAQ?
Avez-vous consulté les manuels?
Pour toute assistance supplémentaire, contactez le service clientèle de Brother:
Modèles apparentés
CM260, CM300, CM600, CM700, CM750, CM840, CM900
Commentaires sur le contenu
Merci d'indiquer vos commentaires ci-dessous. Ils nous aideront à améliorer notre support.