Innov-is 500D

FAQ et Diagnostic

FAQ et Diagnostic
  • Date: 25/02/2009
  • ID: faqh00000012_000

The thread is looping when I try to wind a bobbin.

Looping while winding the bobbin could be caused by several reasons.

 


  • The thread may not be threaded through the thread guide properly.
    Rethread guide following the diagram on the machine.
    Be sure to pass the thread as far as possible into the two slits in the thread guide.
    Be sure to pass the thread as far as possible into the two slits in the thread guide.
    1 Thread guide for bobbin winding
    2 Two slits
  • The bobbin winder cover may not be pushed all the way open. When opening the bobbin winder cover, make sure it is push open as far as it will go.
    When opening the bobbin winder cover, make sure it is push open as far as it will go.
  • The thread could be winding off to quickly. When using threads such as transparent nylon thread or metallic threads, place the spool net over the spool before placing the spool of thread onto the spool pin.
    Place the spool net over the spool before placing the spool of thread onto the spool pin. 1 Spool net
    2 Spool
    3 Spool pin
    4 Spool cap

Si vous n'avez pas obtenu de réponse satisfaisante à votre question, avez-vous vérifié d'autres FAQ?

Avez-vous consulté les manuels?

Pour toute assistance supplémentaire, contactez le service clientèle de Brother:

Modèles apparentés

CS-8060, Innov-is 500D

Commentaires sur le contenu

Merci d'indiquer vos commentaires ci-dessous. Ils nous aideront à améliorer notre support.

Étape 1: Comment qualifieriez-vous les informations figurant sur cette page?

Étape 2: Souhaitez-vous ajouter des commentaires?

Ce formulaire a pour seul but de nous faire part de vos commentaires.

Envoyer