Innov-is 500D
![]() |
FAQ et Diagnostic |
![](/g/b/img/product/hf_inov500deuk.jpg)
Innov-is 500D
Date: 25/02/2009 ID: faqh00000012_000
The thread is looping when I try to wind a bobbin.
Looping while winding the bobbin could be caused by several reasons.
- The thread may not be threaded through the thread guide properly.
Rethread guide following the diagram on the machine.
Be sure to pass the thread as far as possible into the two slits in the thread guide.Thread guide for bobbin winding
Two slits
- The bobbin winder cover may not be pushed all the way open. When opening the bobbin winder cover, make sure it is push open as far as it will go.
- The thread could be winding off to quickly. When using threads such as transparent nylon thread or metallic threads, place the spool net over the spool before placing the spool of thread onto the spool pin.
Spool net
Spool
Spool pin
Spool cap
CS-8060, Innov-is 500D
Pour toute assistance supplémentaire, contactez le service clientèle de Brother:
Commentaires sur le contenu
Merci d'indiquer vos commentaires ci-dessous. Ils nous aideront à améliorer notre support.
Étape 1: Comment qualifieriez-vous les informations figurant sur cette page?
Étape 2: Souhaitez-vous ajouter des commentaires?
Ce formulaire a pour seul but de nous faire part de vos commentaires.