SDX2200D
|
FAQ & Fehlerbehebung |
The mat is fed in at an angle.
Possible Causes (or Results)
Case1 : |
The mat was inserted into the feed slot at an angle. |
Case2 : |
The corners of the mat are deformed (bent). |
Case3 : |
The rear tray is not pulled out. |
Case4 : |
The feed roller is not positioned correctly. |
Case5 : |
The shaft is released. |
Solutions
----- Case1 -----
Press the (Feed) button to feed out the mat.
Re-insert the mat straight in.
----- Case2 -----
Replace the mat with a new one.
----- Case3 -----
Pull out the rear tray.
----- Case4 -----
Adjust the position of the feed roller.
For details, refer to Adjusting the Position of the Feed Roller
----- Case5 -----
Lock the shaft.
Wenn Ihre Frage nicht beantwortet werden konnte, haben Sie andere FAQ geprüft?
Haben Sie in den Handbüchern nachgesehen?
Wenn Sie weitere Unterstützung benötigen, wenden Sie sich an den Brother-Kundendienst:
Relevante Modelle
SDX1000, SDX1200, SDX1250, SDX1350, SDX1500, SDX1550, SDX2200D, SDX2250D, SDX900, SDX950, SDX950SK
Rückmeldung zum Inhalt
Helfen Sie uns dabei, unseren Support zu verbessern und geben Sie uns unten Ihre Rückmeldung.