Search

Home > Security > Use IPsec > Configure IPsec Using Web Based Management

Configure IPsec Using Web Based Management

The IPsec connection conditions comprise two Template types: Address and IPsec. You can configure up to 10 connection conditions.
  1. Start your web browser.
  2. Type "https://machine's IP address" in your browser's address bar (where "machine's IP address" is your machine's IP address).

    For example:

    https://192.168.1.2

  3. If required, type the password in the Login field, and then click Login.
    image
    The default password to manage this machine’s settings is located on the back of the machine and marked "Pwd".
  4. Go to the navigation menu, and then click Network>Security>IPsec.
    image
    Start from image, if the navigation menu is not shown on the left side of the screen.
  5. Configure the settings.
    Option Description
    Status

    Enable or disable IPsec.

    Negotiation Mode

    Select Negotiation Mode for IKE Phase 1. IKE is a protocol that is used to exchange encryption keys in order to carry out encrypted communication using IPsec.

    In the Main mode, the processing speed is slow, but the security is high. In the Aggressive mode, the processing speed is faster than in the Main mode, but the security is lower.

    All Non-IPsec Traffic

    Select the action to be taken for non-IPsec packets.

    When using Web Services, you must select Allow for All Non-IPsec Traffic. If you select Drop, Web Services cannot be used.

    Broadcast/Multicast Bypass

    Select Enabled or Disabled.

    Protocol Bypass

    Select the checkboxes for the option or options you want.

    Rules

    Select the Enabled checkbox to activate the template. When you select multiple checkboxes, the lower numbered checkboxes have priority if the settings for the selected checkboxes conflict.

    Click the corresponding drop-down list to select the Address Template that is used for the IPsec connection conditions. To add an Address Template, click Add Template.

    Click the corresponding drop-down list to select the IPsec Template that is used for the IPsec connection conditions. To add an IPsec Template, click Add Template.

  6. Click Submit.

    If the machine must be restarted to register the new settings, the restart confirmation screen will appear.

    If there is a blank item in the template you enabled in the Rules table, an error message appears. Confirm your choices and click Submit again.

Did you find the information you needed?