Home > Machine Settings > Change Machine Settings from the Control Panel > General Settings > Set the Continue Mode
Set the Continue Mode
The Continue Mode forces the machine to continue printing after the control panel indicates ""Replace Toner" status" and the printing will continue until the control panel indicates ""Toner Ended" status".
This mode is disabled by default. To enable it, change the setting to “Continue”.
- When the control panel indicates an error, you cannot change the mode.
- If you continue printing in the Continue Mode, we cannot guarantee the print quality. To exit Continue Mode, change the setting to “Stop”.
- While using Continue Mode the print may appear faint.
- After you have replaced the toner cartridge with a new one, Continue Mode will be automatically disabled.
- Some machines may not print even if they are in Continue Mode and the “Replace Toner” status is indicated on the control panel. In this case you must replace the toner.
- Make sure that the top cover is closed and the power cord is plugged in.
- Press
to turn on the machine and make sure only the Ready LED ( 
) lights up. - Press seven times to turn the function On or Off.
All LEDs blink twice when you turn on the Continue Mode.
All LEDs blink once when you turn off the Continue Mode.
Did you find the information you needed?