Home > Network > Wireless Network Settings > Use the Wireless Network > Configure Your Machine for a Wireless Network Using the One Push Method of Wi-Fi Protected Setup™ (WPS)
Configure Your Machine for a Wireless Network Using the One Push Method of Wi-Fi Protected Setup™ (WPS)
If your wireless access point/router supports WPS (PBC: Push Button Configuration), you can use WPS from your machine's control panel Wi-Fi button to configure your wireless network settings.
- Make sure that the power cord is plugged in and the top cover is closed.
- Press
to turn the machine on and make sure only the Ready LED ( 
) lights up. - Press the WPS button on your wireless access point/router.
- Press the Wi-Fi button nine times.
- The machine starts the one-push wireless setting mode.The machine will search for a WLAN access point/router that supports Wi-Fi Protected Setup™ (WPS) for five minutes.
If your wireless device is connected successfully, the Wi-Fi LED lights up.
You have completed the wireless network setup. To install the drivers and software necessary to use your machine, go to your model's Downloads page at support.brother.com/downloads.
Did you find the information you needed?