Waste toner box

Order No. WT-100CL
After you have printed approximately 20,000 pages at 5% coverage for CMYK each, you must change the waste toner box. The actual number of printed pages will vary depending on the print jobs and paper you use.

Waste Toner Box Full message

When the waste toner box is full, the following message appears on the LCD and the printer will stop printing. When you see this message, you must replace the waste toner box:
Waste Toner Full
 
WARNING WARNING
 
DO NOT reuse the waste toner box.
 
DO NOT put the waste toner box into a fire. It could explode.
 
Be careful not to spill the toner. DO NOT inhale or allow it to get into your eyes.

Replacing the waste toner box

1
Turn off the printer power switch. Press the front cover release button and then open the front cover.
Graphic
2
Hold the green handle of the drum unit. Lift the drum unit up and then pull it out until it stops.
Graphic
3
Release the gray lock lever (1) that is on the left side of the printer. Pull the drum unit completely out of the printer using the green handles on the drum unit.
Graphic
CAUTION CAUTION
 
Hold the green handles of the drum unit when you carry it. DO NOT hold the sides of the drum unit.
Graphic
 
We recommend that you place the drum unit and belt unit on a clean, flat surface with a piece of disposable paper underneath it in case you accidentally spill or scatter toner.
 
If toner scatters on your hands or clothes, wipe or wash it off with cold water at once.
 
To prevent damage to the printer from static electricity, DO NOT touch the electrodes shown in the illustration.
Graphic
4
Hold the green parts of the belt unit with both hands and lift the belt unit up, then pull it out.
Graphic
5
Remove the waste toner box from the printer using the green handle.
Graphic
CAUTION CAUTION
 
Handle the waste toner cartridges carefully in case you accidentally spill or scatter toner. If toner scatters on your hands or clothes, wipe or wash it off with cold water at once.
Note Note
 
Discard the used waste toner box according to local regulations, keeping it separate from domestic waste. If you have questions, call your local waste disposal office.
6
Unpack the new waste toner and put the new waste toner box in the printer using the green handle.
Graphic
7
Put the belt unit back in the printer. Match the Bsymbol.darr mark on the belt unit to the Bsymbol.uarr mark on the printer. Push down on the green area of the belt unit to lock it in place.
Graphic
8
Put the drum unit back in the printer as follows.
(1)
Make sure that the gray lock lever (1) is in the up position and put the drum unit in the printer. Push down the gray lock lever (1).
Graphic
Note Note
 
When you put the drum unit in the printer, match the green guides (1) of the drum unit handle to the green arrows (2) on both sides of the machine.
Graphic
(2)
Push the drum unit in until it stops.
Graphic
9
Close the front cover.