Home PrintPrevious Next

5 Wireless configuration for Macintosh® using the Brother automatic installer application

Configuration with an access point that supports SecureEasySetup™

Note Note
 
If you are going to connect the printer to your network, we recommend that you contact your system administrator prior to installation.
1
Make sure that the power cord is plugged in.
2
Turn on your printer and wait until the printer is in the Ready state.
3
Turn on your Macintosh®.
4
Put the supplied CD-ROM into your CD-ROM drive. Double-click the HL4040_4050_4070 icon on your desktop. Double-click the Start Here icon. Select your printer and the language.
Screen
5
Click Install Printer Driver.
Screen
6
Click Wireless Network users.
Screen
7
Choose Wireless Setup and Driver Install or Wireless Setup Only, and then click Next.
Screen
8
Read the Important Notice and check the box after you confirm this setting, and then click Next.
Screen
9
Choose I’d like to use the SecureEasySetup™ function of my access point to configure my wireless device. and click Next.
Screen
10
Confirm the on-screen message and click Next.
Screen
11
Refer to the instruction manual that came with your access point to use the SecureEasySetup™ mode of your access point.
12
Put the printer in SecureEasySetup™ mode using the control panel.
(1)
Press any of the Menu buttons (+, -, OK or Back) to take the printer off-line.
Ready
 
next
Select Bsymbol.utriBsymbol.dtri or OK
Machine Info.
(2)
Press the + or - button to select LAN.
Select Bsymbol.utriBsymbol.dtri or OK
LAN
(3)
Press OK to move to the next menu level.
LAN
Wired
(4)
Press the + or - button to select WLAN.
LAN
WLAN
(5)
Press OK to move to the next menu level.
WLAN
TCP/IP
(6)
Press the + or - button to select Setup WLAN.
WLAN
Setup WLAN
(7)
Press OK to move to the next level.
Setup WLAN
Setup Wizard
(8)
Press the + or - button to select SecureEasySetup.
Setup WLAN
SecureEasySetup
(9)
Press OK.
If the following message appears, press OK again.
WLAN Enable?
On
Note Note
 
The message above only appears when the wireless setting is disabled.
(10)
The wireless network connection status using the SecureEasySetup™ software will be displayed on the control panel; Connecting WLAN, Connected or Connection NG.
 
Connecting WLAN is displayed when the print server is trying to make connections to your router or access point. Wait till either Connected or Connection NG is displayed.
Connected is displayed when the print server is successfully connected to your router or access point. You can now use your printer in a wireless network.
Connection NG is displayed when the print server has not successfully connected to your router or access point. Try starting from 1 again. If the same message is displayed again, reset the print server back to the default factory settings and try again.
Note Note
 
If the LCD shows Connection NG, please try again.
13
Click Next or Finish.
Screen
OK!
 
You have completed the wireless setup. If you chose to install the printer driver in step 5, Go to the next step.
14
Check the box after you confirm that you have completed the wireless settings, and then click Next.
Go to Installing the printer driver.
Screen
Page Top
Home PrintPrevious Next